Roller blinds for IHC output module

12V IHC Roller blinds in the living room

Motorized electric roller blind for IHC

Roller blinds for IHC . Can be connected to an IHC output module, e.g. "IHC Output 230" together with a power supply. 12V power supply included. The motor is a slim model with pipe diameter of Ø38 mm.

This roller blinds is ideal to use when IHC installation is in the home or room in advance. Only a "two conductor cable" must be installed to the roller blind. When power is applied to the roller blind, it rolls in one direction and when the current is reversed it rolls in the other. This is controlled via the relay.

Through IHC, all known IHC components can be used, e.g. For example, IHC wall switches both wireless and wired can be used to control the blinds. IHC remote control can also be used. The top and bottom positions of the drop-down are easily set via the included tool. When ordering, width x height must be specified and the blinds will be made to the exact width and height. The width of the roller can be cut down to a cm. The roller curtain is easily mounted in the ceiling or on a wall with reversible brackets. Four screws are required, these are included. Also included are screws for the screws so that they are not seen after mounting. To see how to connect the motor to the KNX system see the diagram.

The roller blinds run elegantly and are quiet.

-- ORDER HERE --